Hot Bimetallic Hammer

Jaw Plate are the most frequently replaced wear parts of Jaw crusher, The quality of the jaw die is important factors to reduce the crushing cost and effciency by increasing opertion time.

A set of jaw plates are consist with the Fixed Jaw Plate (stationary jaw Plate) Swin Jaw Plate (Movable jaw Plate) The Swin jaw is moving eccentricly pushing the rock To the fixed jaw against the fixed jaw die. The compression result the rock getting crack in the chamber and it reamains until it is small enough to pass through the gap. 

Cold-Bimetallic Hammer

The cheek plates is lining at two sides of the jaw crusher cavity to be mount with Jaw frame by bolt and nut, The Lining plates are subject to high stresabrasions during fromthe crushing cycle and material flows,So the lower Side plates is wear faster than the upper side plates.

 

The Liner plate usually made with Manganese steel or Hardox steel plate according to the material requirment. It also having Right Hand (RH) and left hand (LH) sides and some brands of side plates can be used at both sides. 

TIC-Rod Inserts Hammer

The Jaw Wedge usually changing when replacement of the jaw plates, it is mainly for fastern the jaw plates by the taper match with jaw and lock with bolt nut, It has fixed jaw lock, swing jaw wedge Taper and flat one. Each crusher having different design of Jaw Locks, it has up down,and Middles locks to suit different models of crushers